Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 390)

364 Unified IP MIB Reference
53-1003106-01
Port MAC security interface MAC table
33
Port MAC security interface MAC table
The following table shows the same information as the show port security mac ethernet slot/port
CLI command.
Port MAC security autosave MAC table
The following table shows the same information as the show port security autosave CLI command.
Name, OID, and syntax Access Description
snPortMacSecurityIntfMacTable
brcdIp.1.1.3.24.1.1.4 None The port MAC security interface MAC table that shows the port
MAC security status for each Ethernet interface.
snPortMacSecurityIntfMacIfIndex
brcdIp.1.1.3.24.1.1.4.1.1
Syntax: Integer Read-only Shows the ifIndex value of the local interface.
snPortMacSecurityIntfMacAddres
s
brcdIp.1.1.3.24.1.1.4.1.2
Syntax: MAC Address Read-only The secure MAC addresses for this local Ethernet interface on
which the secure MAC address is configured and learned. The
maximum number of the secure MAC addresses is restricted by
the object
snPortMacSecurityIntfContentMaxLockedMacAllowed.
snPortMacSecurityIntfMacVlanId
brcdIp.1.1.3.24.1.1.4.1.3
Syntax: Unsigned32 Read-write The VLAN membership of this interface. A value of zero
indicates it is not applicable.
snPortMacSecurityIntfMacRowSt
atus
brcdIp.1.1.3.24.1.1.4.1.4
Syntax: Integer Read-write Controls the management of the table rows. The following
values can be written:
•
delete(3) – Delete the row.
•
create(4) – Create a new row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
snPortMacSecurityAutosaveMac
Table
brcdIp.1.1.3.24.1.1.5 None The port MAC security autosave MAC table that shows the secure
MAC addresses that were saved automatically.
snPortMacSecurityAutosaveMac
IfIndex
brcdIp.1.1.3.24.1.1.5.1.1
Syntax: Integer32 Read-only Shows the ifIndex value of the local interface.
snPortMacSecurityAutosaveMac
Resource
brcdIp.1.1.3.24.1.1.5.1.2
Syntax: Integer32 Read-only Indicates the resource used to autosave secure MAC addresses:
•
1 - Local
•
2 - Shared