Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 589)

Unified IP MIB Reference 563
53-1003106-01
PIM virtual interface table
55
Name, OID, and syntax Access Description
snPimVInterfaceTable
brcdIp.1.2.9.1.7 None The PIM virtual interface table.
snPimVInterfaceVifIndex
brcdIp.1.2.9.1.7.1.1
Syntax: Integer Read-only The ifIndex value of this PIM virtual interface. There can be
up to 48 entries.
Valid values: 1 - 48
snPimVInterfaceType
brcdIp.1.2.9.1.7.1.2
Syntax: Integer Read-write Indicates the type of PIM virtual interface the row
represents:
•
tunnel(1)
•
subnet(2) or a physical interface
snPimVInterfaceLocalAddress
brcdIp.1.2.9.1.7.1.3
Syntax: IpAddress Read-write Indicates the IP address of the local end of the interface
being configured.
IP tunneling must also be enabled and defined on the
destination Layer 3 Switch interface.
snPimVInterfaceLocalSubnetMask
brcdIp.1.2.9.1.7.1.4
Syntax: IpAddress Read-only Shows the network mask for the IP address of the PIM
virtual interface. For a tunnel, this should be 0.0.0.0.
snPimVInterfaceRemoteAddress
brcdIp.1.2.9.1.7.1.5
Syntax: IpAddress Read-write Shows the IP address of the remote end of this PIM virtual
interface.
snPimVInterfaceDR
brcdIp.1.2.9.1.7.1.6
Syntax: IpAddress Read-only Defines the designated Layer 3 Switch on this PIM virtual
interface. For point-to-point interfaces, this object has the
value 0.0.0.0.
snPimVInterfaceTtlThreshold
brcdIp.1.2.9.1.7.1.7
Syntax: Integer Read-write Determines the minimum time-to-live (TTL) value to
forward the packets out of this interface.
Valid values: 1 – 31
Default: 1
snPimVInterfaceStatus
brcdIp.1.2.9.1.7.1.8
Syntax: Integer Read-write Controls the management of the table rows. The following
valuescan be written:
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4)
returns a “bad value” error. Deleted rows are removed
from the table immediately.
The following values can be returned on reads:
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
snPimVInterfaceMode
brcdIp.1.2.9.1.7.1.9
Syntax: Integer Read-write Shows the configured mode of this PIM interface:
•
dense(1) – Traffic is initially flooded to all PIM
interface neighbors. Branches that do not want the
data are pruned.
•
sparse(2) – PIM interface neighbors must join the
multicast group if they want to receive the traffic.
Default: dense(1)