Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 183)

Unified IP MIB Reference 157
53-1003106-01
Agent board table
5
snAgentBrdAlarmLeds
brcdIp.1.1.2.2.1.1.14
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLXe, Brocade
NetIron MLX, Brocade
NetIron XMR, Brocade
NetIron CES, and
Brocade NetIron CER
series devices.
Read-only Applies to devices with an alarm LED. This object has been
replaced by the object snAgentBrdAlarmLedString.
The value of this LED can be one of the following:
•
0 – No alarm
•
1 – Alarm
snAgentBrdTxTrafficLeds
brcdIp.1.1.2.2.1.1.15
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLXe, Brocade
NetIron MLX, Brocade
NetIron XMR, Brocade
NetIron CES, and
Brocade NetIron CER
series devices.
Read-only Applies only to POS modules that have an LED. This object has
been replaced by the object snAgentBrdTxTrafficLedString.
The value of this LED can be one of the following:
•
0 – No transmit traffic
•
1 – Transmit traffic
snAgentBrdRxTrafficLeds
brcdIp.1.1.2.2.1.1.16
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLXe, Brocade
NetIron MLX, Brocade
NetIron XMR, Brocade
NetIron CES, and
Brocade NetIron CER
series devices.
Read-only Applies only to POS modules that have an LED for transmit traffic,
but this object has been replaced by the object
snAgentBrdRxTrafficLedString.
The value of this LED can be one of the following:
•
0 – off (Not receive traffic)
•
1 – on (Receive traffic)
snAgentBrdStatusLedString
brcdIp.1.1.2.2.1.1.17
Syntax: OCTET STRING Read-only The object contains an octet string that shows the value of the
status of the link LED on the front panel. Each LED is encoded into
1 bit for each switch port.. The value of each bit can be one of the
following:
•
0 – Link is off
•
1 – Link is on
snAgentBrdTrafficLedString
brcdIp.1.1.2.2.1.1.18
Syntax: OCTET STRING Read-only A bit array that contains the value of the front panel traffic LEDs.
This is a packed bit string; each LED is encoded into 1 bit for each
switch port. The value of each bit can be one of the following:
•
0 – No traffic
•
1 – Traffic is flowing
Name, OID, and syntax Access Description