Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 59)

Unified IP MIB Reference 33
53-1003106-01
RFC 2934: Protocol Independent Multicast MIB for IPv4
2
pimNeighborTable (PIM neighbor table)
Use the show ip pim neighbor command to display information about the PIM neighbor table.
The SET request is not supported for this table.
)
pimIpMRouteTable (PIM IP multicast route table)
The show ip pim mcache command displays information about the PIM IP multicast route table.
pimInterfaceNetMask 1.3.6.1.3.61.1.1.2.1.3 Yes, but read-only.
pimInterfaceMode 1.3.6.1.3.61.1.1.2.1.4 Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe , Brocade
NetIron XMR , Brocade
NetIron CES , and Brocade
NetIron CER series devices,
only dense and sparse
modes are supported.
pimInterfaceDR 1.3.6.1.3.61.1.1.2.1.5 Yes, but read-only.
pimInterfaceHelloInterval 1.3.6.1.3.61.1.1.2.1.6 Yes, but read-only.
pimInterfaceStatus 1.3.6.1.3.61.1.1.2.1.7 Yes, but read-only. Returns “active”.
pimInterfaceJoinPruneInter
val 1.3.6.1.3.61.1.1.2.1.8 Yes, but read-only.
pimInterfaceCBSRPreferen
ce 1.3.6.1.3.61.1.1.2.1.9 Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe , Brocade
NetIron XMR , Brocade
NetIron CES , and Brocade
NetIron CER series devices,
the constant value for this
object is 0.
Object Object identifier Supported?
pimNeighborAddress 1.3.6.1.3.61.1.1.3.1.1 Yes
pimNeighborIfIndex 1.3.6.1.3.61.1.1.3.1.2 Yes, but read-only.
pimNeighborUpTime 1.3.6.1.3.61.1.1.3.1.3 Yes, but read-only.
pimNeighborExpiryTime 1.3.6.1.3.61.1.1.3.1.4 Yes, but read-only.
pimNeighborMode 1.3.6.1.3.61.1.1.3.1.5 Yes, but read-only.
Object Object identifier Supported?
ipMRouteGroup 1.3.6.1.2.1.83.1.1.2.1.1 Yes, but read-only.
ipMRouteSource 1.3.6.1.2.1.83.1.1.2.1.2 Yes, but read-only.
ipMRouteSourceMask 1.3.6.1.2.1.83.1.1.2.1.3 Yes, but read-only.
Object Object identifier Supported?