Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 595)

Unified IP MIB Reference 569
53-1003106-01
Chapter
56
IGMP MIB Definition
In this chapter
• General IGMP objects . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 569
• IGMP interface table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 570
• IGMP static group table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 570
General IGMP objects
NOTE
This section describes the Internet Group Management Protocol (IGMP) MIB objects that are
supported in the Unified IP MIB. The objects in this chapter are not supported on the Brocade MLXe,
Brocade NetIron MLX, Brocade NetIron XMR, Brocade NetIron CES, Brocade NetIron CER series, and
Brocade FastIron devices.
The following general IGMP objects are available in all devices.
Name, OID, and syntax Access Description
snIgmpQueryInterval
brcdIp.1.2.6.1.1
Syntax: Integer Read-write Specifies how often the Layer 3 Switch sends out IGMP host
query packets to query an interface for group membership.
Valid values: 0 – 3600 seconds
NOTE: For FastIron platforms, the configuration ranges from 10
through 3600 seconds.
Default: 60 seconds
For a Layer 3 Switch, the
“snDvmrpEnable” object must be set to
“enabled(1)” before this object can be written.
For a Layer 2 Switch, the
“snSwGroupIpMcastMode” object must
be set to “enabled(1)” and the “snSwIpMcastQuerierMode”
object must be set to “querier(1)” before this object can be
written.
snIgmpGroupMembershipTime
brcdIp.1.2.6.1.2
Syntax: Integer Read-write Specifies how many seconds an IP multicast group can remain on
a Layer 3 Switch interface in the absence of a group report.
Valid values: 0 – 7200 seconds
NOTE: For FastIron platforms, the configuration ranges from 20
through 7200 seconds.
Default: 140 seconds
For a Layer 3 Switch, the
“snDvmrpEnable” object must be set to
“enabled(1)” before this object can be written.
For a Layer 2 Switch, the
“snSwGroupIpMcastMode” object must
be set to “enabled(1)” before this object can be written.