Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 285)

Unified IP MIB Reference 259
53-1003106-01
Packet port information table
16
snPOSInfoKeepAlive
brcdIp.1.2.14.1.1.1.13
Syntax: Integer Read-write The time interval when keepalive messages are sent.
Default: 10 seconds
snPOSInfoFlagC2
brcdIp.1.2.14.1.1.1.14
Syntax: Integer Read-write The value of the c2 flag in the SONET headers of packets
transmitted by the interface. The c2 flag identifies the payload type
of the packets transmitted on this interface.
Default: 0xcf, which means that the payload is SONET or SDH.
snPOSInfoFlagJ0
brcdIp.1.2.14.1.1.1.15
Syntax: Integer Read-write The value of the j0 flag in the SONET headers of packets
transmitted by the interface. This flag sets the trace byte, which is
used to trace the origin of an STS-1 frame on a SONET network.
Default: 0xcc
snPOSInfoFlagH1
brcdIp.1.2.14.1.1.1.16
Syntax: Integer Read-write The value of the h1 flag in the SONET headers of packets
transmitted by the interface. This flag sets the H1 pointer, which is
used to indicate where the Synchronous Payload Envelope
(SPE)starts within the packet. The SPE contains the packet’s
payload:
•
0x00 – The pointer for SONET frames.
•
0x02 – The pointer for SDH frames.
Default: 0x00
snPOSStatsInFrames
brcdIp.1.2.14.1.1.1.17
Syntax: Counter Read-only The total number of packets received on the interface.
snPOSStatsOutFrames
brcdIp.1.2.14.1.1.1.18
Syntax: Counter Read-only The total number of packets transmitted out of the interface.
snPOSStatsAlignErrors
brcdIp.1.2.14.1.1.1.19
Syntax: Counter Read-only The number of packets that contained frame alignment errors.
snPOSStatsFCSErrors
brcdIp.1.2.14.1.1.1.20
Syntax: Counter Read-only The number of packets that contained Frame Check Sequence
(FCS) errors.
snPOSStatsFrameTooLong
s
brcdIp.1.2.14.1.1.1.21
Syntax: Counter Read-only The number of packets that were longer than the configured MTU.
snPOSStatsFrameTooShort
s
brcdIp.1.2.14.1.1.1.22
Syntax: Counter Read-only The number of packets that were shorter than the minimum valid
length.
snPOSStatsInDiscard
brcdIp.1.2.14.1.1.1.23
Syntax: Counter Read-only The number of inbound packets that were discarded to prevent
them from being delivered to a higher-layer protocol, even though
no errors had been detected. For example, a packet may be
discarded to free up buffer space.
snPOSStatsOutDiscard
brcdIp.1.2.14.1.1.1.24
Syntax: Counter Read-only The number of outbound packets that were discarded to prevent
them from being transmitted, even though they contain no errors.
For example, a packet may be discarded to free up buffer space.
Name, OID, and syntax Access Description