Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 479)

Unified IP MIB Reference 453
53-1003106-01
IP filter table
46
IP filter table
An IP filter is an access policy that determines whether the device forwards or drops IP packets. A
filter consists of source and destination IP information and the action to take when a packet
matches the values in the filter.
NOTE
The following table is not supported on the Brocade MLXe, Brocade NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
The following objects define IP filters.
snRtIpStaticRouteMask
brcdIp.1.2.2.2.1.3
Syntax: IpAddress Read-write Shows the subnet mask of the default router destination IP
address. The subnet mask of the default router is 0.0.0.0.
snRtIpStaticRouteNextHop
brcdIp.1.2.2.2.1.4
Syntax: IpAddress Read-write Shows the IP address of the next-hop router (gateway) for the
route.
snRtIpStaticRouteMetric
brcdIp.1.2.2.2.1.5
Syntax: Integer32 Read-write Shows the metrics to next-hop router.
Default: 1
snRtIpStaticRouteRowStatus
brcdIp.1.2.2.2.1.6
Syntax: Integer Read-write Controls the management of the table rows. The following values
can be written:
•
delete(3) – Delete the row.
•
create(4) – Create a new row.
•
modify(5) – Modify an existing row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
other(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
snRtIpStaticRouteDistance
brcdIp.1.2.2.2.1.7
Syntax: Integer Read-write Specifies the administrative distance of the route. When
comparing equal routes to a destination, the Layer 3 Switch
prefers lower administrative distances over higher ones.
Valid values: 1 – 255
Default: 1
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snRtIpFilterTable
brcdIp.1.2.2.3 None The IP filter table.
snRtIpFilterIndex
brcdIp.1.2.2.3.1.1
Syntax: Integer32 Read-only Shows the index for an entry in the IP filter table.