Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 241)

Unified IP MIB Reference 215
53-1003106-01
ifIndex to optical parameters table
9
ifIndex to optical parameters table
If the table provides an ifIndex, the ifIndex to optical parameters table returns the optical
parameters for the ifIndex.
NOTE
The following objects provide information for POS and Ethernet optical monitoring. They are
equivalent to the output of the show optics command.
Name, OID, and syntax Access Description
snIfIndexLookup2Table
brcdIp.1.1.3.3.8 None The ifIndex to interface ID2 lookup table.
snIfIndexLookup2IfIndex
brcdIp.1.1.3.3.8.1.1
Syntax: Integer32 Read-only Shows the interface in the ifIndex format.
snIfIndexLookup2InterfaceId
brcdIp.1.1.3.3.8.1.2
Syntax: InterfaceId Read-only Shows the interface ID, which consists of the following:
Octet 0 – Port type, which can be one of the following:
•
1 – Ethernet
•
2 – POS
•
3 – ATM
•
4 – Virtual
•
5 – Loopback
•
6 – GRE Tunnel
The values 1 - 6 applies to Brocade NetIron devices.
•
7 – ATM Subif
•
8 – MPLS Tunnel
•
9 – ATM PVC
•
10 – Management
•
11 – Trunk
•
12 – IP Tunnel (for IP tunnels, except MPLS)
This value also applies to 6 - 4 tunnels in the Brocade
NetIron devices,
Octet 1
•
If the value of Octet 0 is 1, 2, 3, 7, or 9, then this octet
shows the slot number of the device.
•
If the value of Octet 0 is 6 or 8, then this octet shows the
tunnel ID.
•
If the value of Octet 0 is 5, then this octet shows the
loopback ID.
•
If the value of Octet 0 is 4, then this octet shows a virtual ID.
Octet 2 – If the value of Octet 0 is 1, 2, 3, 7, or 9, then this octet
shows the port number.
Octet 3 – If the value of Octet 0 is 7 or 9, then this octet shows
the ATM Subif number.
Octet 4 – If the value of Octet 0 is 9, then this octet shows the
ATM VPI number.
Octet 5 – If the value of Octet 0 is 9, then this octet shows the
ATM VCI number.