Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 330)

304 Unified IP MIB Reference
53-1003106-01
VLAN by port information table
23
snVLanByPortQos
brcdIp.1.1.3.2.1.1.4
Syntax: Integer Read-write Shows the QoS settings for the following devices:
Standalone:
•
low(0) – Low priority
•
high(1) – High priority
BigIron
•
level0(0)
•
level1(1)
•
level2(2)
•
level3(3)
•
level4(4)
•
level5(5)
•
level6(6)
•
level7(7)
snVLanByPortStpMode
brcdIp.1.1.3.2.1.1.5
Syntax: Integer Read-write Indicates whether or not the Spanning Tree mode in the switch
group is enabled:
•
disable(0) - No Spanning Tree
•
enableStp(1) - Activate Spanning Tree
•
enableRstp(2) - Activate Rapid Spanning Tree
snVLanByPortStpPriority
brcdIp.1.1.3.2.1.1.6
Syntax: Integer Read-write Shows the value of the dot1dStpPriority, which is the first two octets
of the STP bridge ID. The STP bridge ID is eight octets long. This
object contains the writable portion of the bridge ID.
The last six octets are contained in the dot1dBaseBridgeAddress of
the snVLanByPortBaseBridgeAddress object.
Valid values: 1 – 65535
snVLanByPortStpGroupMax
Age
brcdIp.1.1.3.2.1.1.7
Syntax: Integer Read-write Shows the value of dot1dStpBridgeMaxAge, which is the last six
octets of the STP bridge ID. All bridges use this object for MaxAge
when this bridge is acting as the root.
NOTE: 802.1D-1990 specifies that the range for this parameter is
related to the value of dot1dStpBridgeHelloTime in the
“snVLanByPortStpGroupHelloTime” object.
The granularity of this timer is specified by 802.1D-1990 to
be one second. An agent may return a bad value error if a
set is attempted to a value which is not a whole number of
seconds. (Refer to RFC 1493 Bridge MIB.)
Valid values: 6 – 40
snVLanByPortStpGroupHell
oTime
brcdIp.1.1.3.2.1.1.8
Syntax: Integer Read-write Shows the value of the dot1dStpBridgeHelloTime, which is the value
used by all bridges when this bridge is acting as the root.
NOTE: The granularity of this timer is specified by 802.1D-1990 to
be one second. An agent may return a bad Value error if a
set is attempted to a value which is not a whole number of
seconds. (Refer to RFC 1493 Bridge MIB.)
Valid values: 1 – 10
Name, OID, and syntax Access Description