Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 579)

Unified IP MIB Reference 553
53-1003106-01
DVMRP route table
53
DVMRP route table
DVMRP uses a routing table instead of the unicast routing table. The DVMRP route table contains
information on the DVMRP source and destination routes.
NOTE
The following table is not supported on the Brocade MLXe, Brocade NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
Name, OID, and syntax Access Description
snDvmrpNeighborTable
brcdIp.1.2.5.1.14 None The DVMRP neighbor table.
snDvmrpNeighborEntryIndex
brcdIp.1.2.5.1.14.1.1
Syntax: Integer32 Read-only The table entry index.
snDvmrpNeighborVifIndex
brcdIp.1.2.5.1.14.1.2
Syntax: Integer32 Read-only The value of VifIndex for the virtual interface used to reach this
DVMRP neighbor.
snDvmrpNeighborAddress
brcdIp.1.2.5.1.14.1.3
Syntax: IpAddress Read-only Shows the IP address of the DVMRP neighbor for which this entry
contains information.
snDvmrpNeighborUpTime
brcdIp.1.2.5.1.14.1.4
Syntax: Time ticks Read-only Shows the time since this DVMRP neighbor became a neighbor of
the local router.
snDvmrpNeighborExpiryTime
brcdIp.1.2.5.1.14.1.5
Syntax: Time ticks Read-only Shows the number of seconds remaining before this DVMRP
neighbor will be aged out.
snDvmrpNeighborGenerationId
brcdIp.1.2.5.1.14.1.6
Syntax: Integer32 Read-only Shows the neighboring router generation identifier.
snDvmrpNeighborMajorVersion
brcdIp.1.2.5.1.14.1.7
Syntax: Integer Read-only Shows the neighboring router major DVMRP version number.
Valid values: 0 – 255
snDvmrpNeighborMinorVersion
brcdIp.1.2.5.1.14.1.8
Syntax: Integer Read-only Shows the neighboring router minor DVMRP version number.
Valid values: 0 – 255
snDvmrpNeighborCapabilities
brcdIp.1.2.5.1.14.1.9
Syntax: Integer32 Read-only Describes the neighboring router capabilities. The following list
shows the position of each bit:
•
3 – Trace bit. If on, neighbor can handle mtrace requests.
•
2 – GenerationID bit. If on, the neighbor sends its
generationID in probe messages.
•
1 – Prune bit. If on, the neighbor supports pruning.
•
0 – Leaf bit. If on, the neighbor has only one interface with
other neighbors.