Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 338)

312 Unified IP MIB Reference
53-1003106-01
VLAN by protocol configuration table
23
VLAN by protocol configuration table
The following table applies to protocol VLANs.
NOTE
The following table is not supported on the Brocade MLXe, Brocade NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
Name, OID, and syntax Access Description
snVLanByProtocolTable
brcdIp.1.1.3.2.2 None The VLAN by protocol configuration table.
snVLanByProtocolEntry
brcdIp.1.1.3.2.2.1 None An entry in the VLAN by protocol configuration table.
snVLanByProtocolVLanId
brcdIp.1.1.3.2.2.1.1 Read-only Shows the VLAN ID index to both the VLAN by port information table
and this table.
snVLanByProtocolIndex
brcdIp.1.1.3.2.2.1.2
Syntax: Integer Read-only Shows the protocol used by this VLAN.
The following IP/IPX protocols are used by VLANs in Layer 3 VLAN:
•
IP(1)
•
IPX(2)
The following protocols are used in Layer 2 bridging:
•
appleTalk(3)
•
decNet(4)
•
netBios(5)
•
others(6) – Other protocols that are defined here.
snVLanByProtocolDynamic
brcdIp.1.1.3.2.2.1.3
Syntax: Integer Read-write Applies only to switches.
Indicates whether or not dynamic port inclusion is enabled:
•
disabled(0)
•
enabled(1)
snVLanByProtocolStaticMas
k
brcdIp.1.1.3.2.2.1.4
Syntax: PortMask Read-write Indicates the standalone switch Protocol VLAN port membership
(portmask) applied in static mode.
This object was obsoleted for Chassis devices.
snVLanByProtocolExcludeMa
sk
brcdIp.1.1.3.2.2.1.5
Syntax: PortMask Read-write Indicates the standalone switch Protocol VLAN port membership
(portmask) applied in exclusive mode.
This object was obsoleted for Chassis devices.
snVLanByProtocolRouterIntf
brcdIp.1.1.3.2.2.1.6
Syntax: Integer Read-write Applies to routers only and is optional. It shows the virtual interface
of a router to the VLAN.
This object is not configured if an SNMP-Get is equal to zero.