Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 492)

466 Unified IP MIB Reference
53-1003106-01
IPX general objects
48
snIpxClearTrafficCnts
brcdIp.1.2.1.1.5
Syntax: ClearStatus Read-write Indicates if all IPX traffic counters are cleared:
•
normal(0) – Do not clear counters.
•
clear(1) – Clear counters.
The following IPX traffic counters are affected by this object:
•
snIpxRcvPktsCnt
•
snIpxFwdPktsCnt
•
snIpxRcvDropPktsCnt
•
snIpxTxDropPktsCnt
•
snIpxRcvFiltPktsCnt
•
snIpxTxFiltPktsCnt
snIpxRcvPktsCnt
brcdIp.1.2.1.1.6
Syntax: Counter Read-only The number of IPX packets received on the Layer 3 Switch.
snIpxTxPktsCnt
brcdIp.1.2.1.1.7
Syntax: Counter Read-only The number of IPX packets that originated on the Layer 3 Switch and
sent on its port.
snIpxFwdPktsCnt
brcdIp.1.2.1.1.8
Syntax: Counter Read-only The number of IPX packets received by the Layer 3 Switch from another
device and then sent out on its port.
snIpxRcvDropPktsCnt
brcdIp.1.2.1.1.9
Syntax: Counter Read-only The number of packets received by the Layer 3 Switch that the switch
dropped.
snIpxRcvFiltPktsCnt
brcdIp.1.2.1.1.10
Syntax: Counter Read-only The number of packets received by a port that matched an inbound IPX
filter configured on the port.
snIpxRipGblFiltList
brcdIp.1.2.1.1.11
Syntax: OCTET STRING Read-write An IPX RIP global filter list. There can be up to 32 octets in this object.
snIpxRipFiltOnAllPort
brcdIp.1.2.1.1.12
Syntax: Integer Read-write Applies the IPX RIP global filter list in the “snIpxRipGblFiltList” object to
all interfaces. This object adds all RIP filter lists and deletes all RIP filter
lists from all ports. Before sending the command, the
“snIpxRipGblFiltList” object must be defined.
The following values can be written:
•
deleteAllInBound(2) – Deletes all in-bound filter lists from all
ports.
•
deleteAllOutBound(3) – Deletes all out-bound filter lists from all
ports.
•
addAllInBound(4) – Adds all in-bound filter lists to all ports.
•
addAllOutBound(5) – Adds all out-bound filter lists to all ports.
The following values can be returned on reads:
•
noSuch(0) – Set operation has not be performed.
•
valid(1) – Set operation is done and is valid.
snIpxSapGblFiltList
brcdIp.1.2.1.1.13
Syntax: OCTET STRING Read-write An IPX SAP global filter list. There can be up to 32 octets in this object.
Name, OID, and syntax Access Description