Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 173)

Unified IP MIB Reference 147
53-1003106-01
Image version
5
snAgGblResourceLowWarn
ing
brcdIp.1.1.2.1.33
Syntax: Integer Read-only The device has low resources available:
•
No(0)
•
Yes(1)
snAgGblExcessiveErrorWar
ning
brcdIp.1.1.2.1.34
Syntax: Integer Read-only The device has excessive collision, FCS errors, alignment warnings,
and other excessive warnings:
•
No(0)
•
Yes(1)
snAgGblCpuUtilData
brcdIp.1.1.2.1.35
Syntax: Gauge Read-only The statistics collection of utilization of the CPU in the devices.
Reading this object in the Brocade NetIron and FastIron devices will
reset all the counters. Therefore, it is not required to set the object to
snAgGblUtilCollect.
snAgGblCpuUtilCollect
brcdIp.1.1.2.1.36
Syntax: Integer Read-write Enables or disables the collection of CPU utilization statistics in a
device. This can be one of the following:
•
enable(1)
•
disable(0)
snAgGblTelnetTimeout
brcdIp.1.1.2.1.37
Syntax: Integer32 Read-write Shows how many minutes a Telnet session can remain idle before it
times out. Each value unit is one minute. The value of this object can
be up to 240 minutes. A value of 0 means that the Telnet session
never times out.
snAgGblEnableWebMgmt
brcdIp.1.1.2.1.38
Syntax: Integer Read-write Enables or disables access to the device from the Web Management
Interface:
•
disable(0)
•
enable(1)
snAgGblSecurityLevelBindi
ng
brcdIp.1.1.2.1.39
Syntax: Integer32 Read-only After a network management system logs in to a device with a user ID
and password, the privilege level assigned to that system is saved in
this object. The privilege level can be one of the following:
•
Bit 0 – Level 0 = admin
•
Bit 4 – Level 4 = port configuration
•
Bit 5 – Level 5 = read only
•
255 – Invalid binding
snAgGblEnableSLB
brcdIp.1.1.2.1.40
Syntax: Integer
NOTE: This object is not
supported on the
Brocade MLX
Series and
Brocade NetIron
CER series
devices.
Read-only Enables or disables Server Load Balancing:
•
disable(0)
•
enable(1)
Name, OID, and syntax Access Description