Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 54)

28 Unified IP MIB Reference
53-1003106-01
RFC 2932: IPv4 Multicast Routing MIB
2
ipMRouteNextHopTable
(IP multicast route next hop table)
In this table, “NextHop” refers to the downstream traffic.
The following CLI commands display information about the objects in the IP multicast route next
hop table:
• show ip pim mcache
• show ip pim neighbor
The SET request is not supported for this table.
.
ipMRouteRtMask 1.3.6.1.2.1.83.1.1.2.1.14 Yes, but read-only.
ipMRouteRtType 1.3.6.1.2.1.83.1.1.2.1.15 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.
ipMRouteHCOctets 1.3.6.1.2.1.83.1.1.2.1.16 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.
Object Object identifier Supported?
ipMRouteNextHopGroup 1.3.6.1.2.1.83.1.1.3.1.1 Yes
ipMRouteNextHopSource 1.3.6.1.2.1.83.1.1.3.1.2 Yes
ipMRouteNextHopSourceMask 1.3.6.1.2.1.83.1.1.3.1.3 Yes
ipMRouteNextHopIfIndex 1.3.6.1.2.1.83.1.1.3.1.4 Yes
ipMRouteNextHopAddress 1.3.6.1.2.1.83.1.1.3.1.5 Yes
ipMRouteNextHopState 1.3.6.1.2.1.83.1.1.3.1.6 Yes, but read-only. Always shows
forwarding(2).
ipMRouteNextHopUpTime 1.3.6.1.2.1.83.1.1.3.1.7 Yes, but read-only.
ipMRouteNextHopExpiryTime 1.3.6.1.2.1.83.1.1.3.1.8 Yes, but read-only.
ipMRouteNextHopClosestMember
Hop 1.3.6.1.2.1.83.1.1.3.1.9 Yes, but read-only.
Object Object identifier Supported?