Igmpcacheaddress, Igmpcacheifindex, Igmpcacheself – Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) User Manual
Page 58: Igmpcachelastreporter, Igmpcacheuptime, Igmpcacheexpirytime, Igmpcachestatus, Igmpcacheversion1hosttimer, Pimjoinpruneinterval, Piminterfacetable (pim interface table)

32
Unified IP MIB Reference
53-1003106-01
RFC 2934: Protocol Independent Multicast MIB for IPv4
2
RFC 2934: Protocol Independent Multicast MIB for IPv4
The following PIM MIB objects are supported on the Brocade NetIron and Brocade FastIron devices.
On the Brocade NetIron XMR, Brocade NetIron MLX, Brocade NetIron CES, and Brocade NetIron
CER series devices, only default VRF is supported.
Support for RFC 2934 in these devices is presented in the following sections.
pimInterfaceTable (PIM interface table)
Use the show ip pim interface command to display information about the PIM interface table.
The SET request is not supported for this table.
Object
Object identifier
Supported?
igmpCacheAddress
1.3.6.1.2.1.85.1.2.1.1
Yes
igmpCacheIfIndex 1.3.6.1.2.1.85.1.2.1.2
Yes
igmpCacheSelf
1.3.6.1.2.1.85.1.2.1.3
Yes, but read-only.
igmpCacheLastReporter 1.3.6.1.2.1.85.1.2.1.4
Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe
,
Brocade
NetIron XMR
,
Brocade
NetIron CES, and Brocade
NetIron CER series
devices,
the constant value for this
object is 0.
igmpCacheUpTime
1.3.6.1.2.1.85.1.2.1.5
Yes, but read-only.
igmpCacheExpiryTime 1.3.6.1.2.1.85.1.2.1.6
Yes, but read-only.
igmpCacheStatus
1.3.6.1.2.1.85.1.2.1.7
Yes, but read-only.
NOTE: On Brocade NetIron MLX
,
Brocade MLXe
,
Brocade
NetIron XMR
,
Brocade
NetIron CES, and Brocade
NetIron CER series
devices,
the constant value for this
object is active(1).
igmpCacheVersion1HostTimer
1.3.6.1.2.1.85.1.2.1.8
Yes, but read-only.
Object
Object identifier
Supported?
pimJoinPruneInterval 1.3.6.1.3.61.1.1.1
Yes, but read-only.
NOTE: The SET operation is not
supported.
Object
Object identifier
Supported?
pimInterfaceIfIndex 1.3.6.1.3.61.1.1.2.1.1
Yes
pimInterfaceAddress
1.3.6.1.3.61.1.1.2.1.2
Yes, but read-only.