Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 505)

Unified IP MIB Reference 479
53-1003106-01
BGP4 general variables
49
snBgp4GenNextBootRoutes
brcdIp.1.2.11.1.7
Syntax: Integer32 Read-write The next boot-configured number of routes. The minimum
value of this MIB is
“snBgp4GenMinRoutes” . The maximum
value of this MIB is “snBgp4GenMaxRoutes” .
snBgp4GenSynchronization
brcdIp.1.2.11.1.8
Syntax: Integer Read-write Enables or disables the synchronization between BGP and
your IGP:
•
disabled(0)
•
enabled(1)
snBgp4GenKeepAliveTime
brcdIp.1.2.11.1.9
Syntax: Integer Read-write Indicates how often the device sends keepalive messages.
Valid values: 1 – 65535 seconds
Default: 60 seconds
snBgp4GenHoldTime
brcdIp.1.2.11.1.10
Syntax: Integer Read-write Determines how many seconds the device will wait for a
keepalive or update message from a BGP4 neighbor before
deciding that the neighbor is dead.
Valid values: 1 – 65535 seconds
Default: 180 seconds
snBgp4GenRouterId
brcdIp.1.2.11.1.11
Syntax: IpAddress Read-write Indicates the BGP router IP address.
snBgp4GenTableMap
brcdIp.1.2.11.1.12
Syntax: OCTET STRING Read-write Defines the route map name. Each character of the name is
represented by one octet.
Valid values: Up to 32 octets.
snBgp4GenAdminStat
brcdIp.1.2.11.1.13
Syntax: Integer Read-write Indicates if BGP4 routing is enabled:
•
disabled(0)
•
enabled(1)
snBgp4GenDefaultMetric
brcdIp.1.2.11.1.14
Syntax: Integer32 Read-write Indicates the default metric values for the BGP4.
The Layer 3 Switches can redistribute directly connected
routes, static IP routes, RIP routes, and OSPF routes into
BGP4. The MED (metric) is a global parameter that specifies
the cost that will be applied to all routes by default when they
are redistributed into BGP4.
Valid values: 0 – 4294967295
snBgp4GenMaxNeighbors
brcdIp.1.2.11.1.15
Syntax: Integer32 Read-only Shows the maximum number of neighbors that can be
configured in a BGP peer group.
snBgp4GenMinNeighbors
brcdIp.1.2.11.1.16
Syntax: Integer32 Read-only Shows the minimum number of neighbors that can be
configured in a BGP peer group.
snBgp4GenMaxRoutes
brcdIp.1.2.11.1.17
Syntax: Integer32 Read-only Shows the maximum number of configured routes.
snBgp4GenMinRoutes
brcdIp.1.2.11.1.18
Syntax: Integer32 Read-only Shows the minimum number of configured routes.
snBgp4GenMaxAddrFilters
brcdIp.1.2.11.1.19
Syntax: Integer32 Read-only Shows the maximum number of configured BGP4 address
filters.
Name, OID, and syntax Access Description