Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 296)

270 Unified IP MIB Reference
53-1003106-01
Stacking configuration unit table
18
Stacking configuration unit table
Use the following table to display and configure stacking information for each unit.
snStackingGlobalPersiste
ntMacTimer
brcdIp.1.1.3.31.1.4
Syntax: Integer32 Read-write Persistent MAC timer in minutes for the stacking system. This timer
shows the number of minutes to retain the original active stack unit's
base MAC address in case the active unit fails or is removed. This timer
is triggered when a new active unit is elected. When the timer expires,
the new active unit will change the stacking MAC address to its own
base MAC address and advertise its own base MAC address to the
management VLAN to update the ARP table of members. If you decide
to use the new active unit's MAC address, you must enter this timer
again to reactivate the persistent MAC address.
Valid values are:
•
0 - Keep it forever
•
5 to 3600 minutes
The default is 60 minutes.
snStackingGlobalTopology
brcdIp.1.1.3.31.1.5
Syntax: Integer Read-only The topology of the stacking system:
•
other(1)
•
chain(2)
•
ring(3)
•
standalone(4)
snStackingGlobalMode
brcdIp.1.1.3.31.1.6
Syntax: Integer Read-only The stacking mode of the system:
•
stackingMode - the system is installed with STK EEPROM
represents it is in stacking mode.
•
nonStackingMode - the system is not installed with STK EEPROM
represents it is not in stacking mode.
snStackingGlobalMixedM
ode
brcdIp.1.1.3.31.1.7
Syntax: Integer Read-only The mixed stacking mode of the system:
•
familyStackingMode - The system is in family stacking mode
(heterogeneous).
•
classicStackingMode - The system is not in family stacking mode
(homogeneous).
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snStackingConfigUnitTable
brcdIp.1.1.3.31.2.1 None The stacking configuration table.
snStackingConfigUnitIndex
brcdIp.1.1.3.31.2.1.1.1
Syntax: Integer None The ID of the unit in a stack.
snStackingConfigUnitPriority
brcdIp.1.1.3.31.2.1.1.2
Syntax: Integer32 Read-write The priority in active or backup election.
Value can be from 0 through 255.
snStackingConfigUnitConfig
StackPort
brcdIp.1.1.3.31.2.1.1.3
Syntax: InterfaceIndex Read-write The IfIndex for the configured stacking port. If no stacking port is
configured, this object displays zero and the first two 10 Gigabit ports
as the default stacking ports. Enter zero to remove the configured
stacking port.