Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 292)

266 Unified IP MIB Reference
53-1003106-01
Stackable management secondary switch information
17
Stackable management secondary switch information
The objects in the following table provide stackable management secondary switch information.
NOTE
The objects in the following table are not supported on Brocade FCX, FastIron GS, and FastIron LS
stacking devices.
snStackSmSlotIndex
brcdIp.1.1.5.1.5
Syntax: Integer Read-write The slot 0 is the master slot and slots 1-8 are slaves. All the slot-based
MIB data can be retrieved with respect to this slot index.
snStackFmpSetProcess
brcdIp.1.1.5.1.6
Syntax: Integer Read-only The state of the FMT set process:
•
normal(0) - The set process is either in an idle state or
FMP-SET-SUCCESS state.
•
pending(1) - The pending process is waiting for the result of an
FMP-SET.
•
failure(2) - The failure result of an FMP-SET.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snStackSecSwitchTable
brcdIp.1.1.5.2.1 None If snSwGroupOperMode is configured as basic mode, which is VLAN by
Port, Layer 2 switching, then this table is valid. Each VLAN switch port
could have a number of VLAN IDs.
snStackSecSwitchIndex
brcdIp.1.1.5.2.1.1.1 Read-only The secondary switch index must not be greater than
snStackMaxSecSwitch.
snStackSecSwitchSlotId
brcdIp.1.1.5.2.1.1.2 Read-write The secondary switch slot ID must be set before the configuration
command sent from the primary switch to the secondary switch either
manually or automatically. Refer to the object
snStackSecSwitchCfgCmd.
snStackSecSwitchPortC
nts
brcdIp.1.1.5.2.1.1.3 Read-only The number of ports in this secondary switch.
snStackSecSwitchEnabl
ed
brcdIp.1.1.5.2.1.1.4 Read-write The secondary switch has been selected to the stackable
management group.
snStackSecSwitchAck
brcdIp.1.1.5.2.1.1.5 Read-only The secondary switch has sent a response to the primary switch.
snStackSecSwitchMacA
ddr
brcdIp.1.1.5.2.1.1.6 Read-only The secondary switch physical address. The physical address
represents a MAC Station.