Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 434)

408 Unified IP MIB Reference
53-1003106-01
Textual conventions
40
Textual conventions
The Layer 2 ACL tables use the following textual conventions.
agAclAccntRaclFwdCnt
brcdIp.1.2.2.15.5.1.12
Syntax: Counter64 Read-only Receive-ACL forward counter used for rate limiting. Not
used for other ACL kind. The value returned is per ACL,
instead of per filter within the ACL.
This object supports rate limiting statistics for ACL and
Layer 2 ACL-enabled interfaces.
agAclAccntRaclRemarkCnt
brcdIp.1.2.2.15.5.1.13
Syntax: Counter64 Read-only Receive-ACL remark counter used for rate limiting. Not
used for other ACL kind. The value returned is per ACL,
instead of per filter within the ACL.
This object supports rate limiting statistics for ACL and
Layer 2 ACL-enabled interfaces.
agAclAccntRaclTotalCnt
brcdIp.1.2.2.15.5.1.14
Syntax: Counter64 Read-only Receive-ACL total counter used for rate limiting. Not used
for other ACL kind. The value returned is per ACL, instead
of per filter within the ACL.
This object supports rate limiting statistics for ACL and
Layer 2 ACL-enabled interfaces.
agAclAccntRaclTotalSWHitCountCnt
brcdIp.1.2.2.15.5.1.15
Syntax: Counter64 Read-only Receive-ACL cumulative software hit counter. Not used for
other ACL kind. The value returned is per ACL, instead of
per filter within the ACL.
Name, OID, and syntax Access Description
Name and syntax Description
fdryVlanIdOrNoneTC
Syntax: Integer32 The VLAN ID that uniquely identifies a specific VLAN, or no VLAN. The special value of
zero is used to indicate that no VLAN ID is present or used. This can be used in any
situation where an object or a table entry must refer either to a specific VLAN, or to no
VLAN.
Valid values: 0 or 1 - 4094
PortQosTC
Syntax: Integer The port QoS priority-hardware queue. The value 0 is the lowest priority and 7 is the
highest.
Valid values:
•
level0(0)
•
level1(1)
•
level2(2)
•
level3(3)
•
level4(4)
•
level5(5)
•
level6(6)
•
level7(7)
•
invalid(127)
fdryEnetTypeOrZeroTC
Syntax: Integer Ethernet Type field within the Ethernet-II frame:
•
invalid(0)
•
ipv4(1)
•
arp(2)
•
ipv6(3)
fdryClauseIndexTC
Syntax: Unsigned 32 One-based clause index value within a given ACL number.