Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 189)

Unified IP MIB Reference 163
53-1003106-01
Boot sequence table
5
Boot sequence table
The boot sequence table shows a list of software image loads. The images are in the sequence that
will be used at boot up. When the devices are booted, the first image in the table will be loaded into
the device. If that software image fails, the second image will be tried. The process continues until
a successful load is completed.
The boot sequence table is available in all devices. The combination of all the objects in this table
must be unique. Duplicate instructions are rejected.
Name, OID, and syntax Access Description
snAgTrpRcvrTable
brcdIp.1.1.2.3.1
Syntax: SEQUENCE OF
SnAgTrpRcvrEntry None The trap receiver table.
snAgTrpRcvrIndex
brcdIp.1.1.2.3.1.1.1
Syntax: Integer Read-only Shows the index in the trap receiver table.
Valid values: 1 – 10
snAgTrpRcvrIpAddr
brcdIp.1.1.2.3.1.1.2
Syntax: IpAddress Read-write Indicates the IP address of the SNMP manager that will receive the trap.
snAgTrpRcvrCommuni
tyOrSecurityName
brcdIp.1.1.2.3.1.1.3
Syntax: OCTET
STRING Read-write Indicates the community string to use to access the trap receiver. This
object can have up to 32 octets.
snAgTrpRcvrStatus
brcdIp.1.1.2.3.1.1.4
Syntax: Integer Read-write Controls the management of the table rows. The following are the values:
•
ignore(5) – Do not send traps to this entry at this time.
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
If the row exists, then a SET with a value of create(5) returns error
"badValue". Deleted rows are deleted immediately.
The following values can be returned on reads:
•
other(1) – Some other case.
•
valid(2) – Row exists and is valid.
•
ignore(5) – Do not send traps to this entry at this time.
snAgTrpRcvrUDPPort
brcdIp.1.1.2.3.1.1.5
Syntax: Integer Read-write Indicates the UDP port number of the trap receiver.
Valid values: 0 – 65535
Default: 162
snAgTrpRcvrSecurityM
odel
brcdIp.1.1.2.3.1.1.6
Syntax: Integer Read-write Allows configuration of security model (v1, v2c, or 3).
snAgTrpRcvrSecurityL
evel
brcdIp.1.1.2.3.1.1.7
Syntax: Integer Read-write Allows configuration of the security level (noauth, auth, or auth+priv).