Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 227)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 225
Filtering LeCroy Corporation
Selectable Filter Options for SAS
The SAS Filter Options are:
 Bus Condition
 Primitive
 Incomplete Frames
 Address Frames
 SSP Frames
 SMP Frames
 STP Frames
 SCSI Commands
 Task Management Functions
 ATA Commands
 SCSI Command Status (see “Filter Check Condition” below)
 Source SAS Address
 Destination SAS Address
 Pair SAS Address
 Protocol Error
 STP Port
 Tag (see “Filter by Tag Number” below)
 ATAPI SCSI Command
 Miscellaneous (see “Miscellaneous” below)
Bus Condition
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Bus Conditions in the Sample Viewer.
Incomplete Frames
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
Incomplete Frames in the Sample Viewer.
ATA Command
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured ATA commands in the Sample Viewer.
Protocol Error
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured packets with the specified Protocol Errors in the Sample Viewer.
ATAPI SCSI Command
When selected, depending on the Filter Type, the Show/Hide selection shows or hides
ATAPI SCSI commands.