Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 126)

LeCroy Corporation Exercise and Capture
124 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
Figure 2.114: SATA: Sample Host Emulator Program
Sample Initiator Emulator Program (SAS only)
Figure 2.115 shows a simple completed SAS Initiator Emulator program.
Figure 2.115: SAS: Sample Initiator Emulator Program
Data Blocks
For commands requiring data blocks, click the down arrow of the 
Payload Data drop‐down combo box and choose from a set of pre‐defined data blocks. If
you need a new data block, select Configuration > Data Block or click the Data Block
icon on the tool bar to open a data block definition dialog ( See “Creating a Data Block” on
page 150. for instructions on creating data blocks).
Exercising Specific Addresses
Since more than one device can be active at any given time, you can specify specific
commands to send to an address. To assign commands to an address:
Option button