Teledyne LeCroy OC910 Oscilloscope Cart - Manual

Instructions
OC910 Oscilloscope Cart
Thank you for purchasing a Teledyne LeCroy OC910 oscilloscope cart for use with a LabMaster 10 Zi system.
These instructions demonstrate two modifications you can make to adapt the cart to your LabMaster
configuration.
Modification 1: Place Four Acquisition Modules
To make room for four LabMaster 10 Zi acquisition modules in the OC910, remove the shelf below the
drawer. This will allow sufficient clearance for two acquisition modules to sit stacked one on top of the other
in the space below the drawer.
Use a metric hex key (3.0 mm across flats) to remove the four fasteners attaching the shelf.
If due to manufacturing variances the acquisition modules still do not fit, remove the rubber grommets on
the bottom side of the drawer for additional clearance.
921542-00 Rev A
1