Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 183)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 181
Target and Device Emulation LeCroy Corporation
nStartAddress: Specifies the start address of the Area.
nEndAddress: Specifies the End address of the Area.
eAreaType: Specifies the Area Type. This parameter should be in
TrgEmulMediaAreaTypeEnum format. Its possible values are:
typedef enum {eNORMAL_WRITABLE = 0, eCIRCULAR_WRITABLE = 1,
eNONE_WRITABLE = 2} TrgEmulMediaAreaTypeEnum;
Choose Target Emulator Port
Click a port option button, then click the Speed Negotiation Setting button (see “Speed
Negotiation Tab” on page 145 ). Select the port speed settings, all by default.
Ports Configuration
Click the Port Configuration button to display the Ports Configuration dialog (see “Ports
Configuration” on page 96 ).
Device Activation
Enter a number of times in the Activate Device field. If Activate Device = 1, the software
activates Target Emulator until you deactivate it. This is the default behavior. (Period of
Activation has no effect.)
If Activate Device = n, where n > 1, the software activates and deactivates
Target Emulator n times, with activation period specified in the period of activation field.
For example, if Activate Device = 10 and period of activation = 2000 ms, the software
activates Target Emulator for 2000 ms and then deactivates it, and then repeats activation
and deactivation 9 times, for a total of 10 times. (You must enter Period of Activation.)
Advanced Settings
Click the Advanced Button to display additional setting options. The dialog opens
displaying the OOB Signal Setting tab.