Clip transition, P338 – Grass Valley EDIUS Pro v.6.5 User Manual
Page 360
Applying Effects
338
EDIUS - Reference Manual
When both clips have no margin
When there is a margin at the end of front clip and at the beginning of back clip
In the extend mode, to add transition/audio cross fade between two clips, both clips need margins. If there is no margin,
switch to the fix mode or create margins by trimming or other operations.
Clip Transition
You can add a transition between 2 clips.
1 Select a transition in the [Effect] palette, and drag and drop it to the joint of clips.
The timeline display changes as shown below. The default audio cross fade is simultaneously added.
Changing Default Effects
2
Alternative
• Select a clip on the timeline and select a transition from the [Effect] palette. Click the [Add to Timeline] list button and
click an item. If you click [Add to Timeline] instead of the list button, the transition is applied to both the In and Out
points of the selected clip.
• Select a clip on the timeline. In the [Effect] palette, right-click a transition, and click [Add to Timeline]
→ an item.
• Select a transition in the [Effect] palette, right-drag it to the clip on the timeline, and click [Add] or [Replace]. Click
[Custom] to specify the duration and the position at which the transition is applied.
3
•
By [Application] in [User Settings]
→ [Timeline], you can set so that the default audio cross fade should not be
applied when the transition is applied.
• In the extend mode, the clip border after setting the transition is displayed as a green line (cut point).
• A clip transition on the timeline can be applied to the joint of other clips by dragging and dropping.