Grass Valley EDIUS Pro v.6.5 - Manual (Page 135)

113
External Device Management
EDIUS - Reference Manual
2 Select a save destination and click [Save].
Assigning Device Presets to Input Presets
If you assign device presets as input presets in advance, an assigned device preset can simply be called up at capture.
1 Select and right-click a preset in the device preset list, and click [Assign Input Preset] → [Input Preset 1] -
[Input Preset 8].
[Device Preset] Screen 0 P106
The selected device preset is assigned as an input preset, and is displayed as an input preset when [Capture] on the
menu bar is clicked.
3
•
To cancel an assignment to an input preset, right-click a blank area in the [Device Preset] list, and click [Delete
assignation]
→ preset name.
Points About Input from VARICAM Devices
Import and edit video shot on VARICAM devices on EDIUS.
The following explains points when using VARICAM devices to input/output video.
Points About Project Settings
When [TC preset] in the project settings is set to other than “00”, the sequence of active frame information may not
match the TC at stream output.
[Project Settings] (Detailed Settings) Dialog Box 0 P39
When the frame rate of the source does not match the frame rate of the project, the pitch is altered so that the audio
speed is changed to keep up with playback duration. If necessary, make adjustments in the waveform editing software
or the pitch shifter of the audio filter.
Registration of Device Presets
Before using VARICAM devices to input/output video, register VARICAM devices connected to the PC via the
IEEE1394 interface in advance as device presets.
To connect the AJ-HD1200A via the IEEE1394 interface, the option board must be attached.
The following explains points when registering VARICAM devices as device presets. For details about the procedure for
registering device presets and other information, see “Registering Device Presets”.
Registering Device Presets 0 P106
When setting [Video Format] at [Input H/W, Format Settings] in the Preset Wizard, refer to the explanation about each
of the following formats:
Points About Capture and Editing
The following explains points and precautions about capture and editing.
The capture operation procedure is the same as that for other devices connected via the IEEE1394 interface.
Importing Sources from DV Tape (Capture) 0 P145
1280 ×1080 59.94i
1440 ×1080 50i
When importing from DVCPRO HD standard-compliant equipment, select the
format that matches the respective frame frequency setting used when the
video was shot.
960 ×720 59.94p Use this when capturing sources taken with VARICAM without referencing
active frame information or when capturing content taken with AJ-HDX900,
for example, whose format signals are 720/59.94p, 720/29.97p or 720/
23.98p.
960 ×720 Constant Rate Shooting
over 60p
960
×720 Constant Rate Shooting
over 59.94p
Select a format that matches the respective VARICAM frame frequency
setting used when the video was shot. Only frames set with active frame
information are captured.
960 ×720 50p Use this when capturing content taken with AJ-HDX900, for example, whose
format signals are 720/50p and 720/25p.