Bayer HealthCare Rapidlab 800 - Manual (Page 420)

5Ć10 800 Series Operator's Manual
Selecting a Default Panel
Use this procedure to select the panel that the system will use to analyze a patient
sample. You can select default panels from a predefined list or from any defined
custom panels. The system measures only the parameters listed in the panel. The
system default is All Parameters. Different predefined panels are available on each
800 system, as shown in Table 5-3.
If you want to individually select parameters as the default set of parameters for
analysis, refer to Selecting Parameters for Analysis, page 5-12.
NOTE: Default panels are used in patient sample analysis only. All parameters are
evaluated during quality control analysis.
Table 5Ć3.āăPanel Options
System Panels Parameters Analyzed
840 All Parameters pH, pO
2
, pCO
2
844 All Parameters
pH/Blood gas
CO-ox pH, pO
2
, pCO
2
, tHb, FO
2
Hb
pH, pO
2
, pCO
2
tHb, FO
2
Hb
845 All Parameters
pH/Blood gas
CO-ox pH, pO
2
, pCO
2
, tHb, FO
2
Hb, FCOHb, FMetHb,
FHHb
pH, pO
2
, pCO
2
tHb, FO
2
Hb, FCOHb, FMetHb, FHHb
850 All Parameters
pH/Blood Gas
pH/lytes
Blood gas/lytes
pH/Ca ++
pH, pO
2
, pCO
2
, Na + , K + , Ca ++ , Cl –
pH, pO
2
, pCO
2
pH, Na + , K + , Ca ++ , Cl –
pO
2
, pCO
2
, Na + , K + , Ca ++ , Cl –
pH, Ca ++
854 All Parameters
pH/Blood gas
CO-ox
pH/lytes
Blood gas/lytes
pH/Ca ++
pH, pO
2
, pCO
2
, Na + , K + , Cl – , Ca ++ , tHb, FO
2
Hb
pH, pO
2
, pCO
2
tHb, FO
2
Hb
pH, Na + , K + , Ca ++ , Cl –
pO
2
, pCO
2
, Na + , K + , Ca ++ , Cl –
pH, Ca ++
(Continued)