Bayer HealthCare Rapidlab 800 - Manual (Page 128)

2Ć30 Rapidlab 800 Operator's Manual
About Patient Sample Results
This section provides an overview of the Patient Sample Results screen and the
printed sample report. Figure 2-17 shows the results screen. Your screen may
appear differently depending on your system and how parameters were defined in
setup.
Figure 2Ć17.ā Patient Sample Results Screen for an 850 System
Draw date and time
The following table describes the symbols seen in patient sample reports:
Symbol Description
****** The sensor is out of calibration.
------
↑
The result is above the measurement range. On the screen, the result, dashes,
and arrow appear in red.
------
↓
The result is below the measurement range. On the screen, the result, dashes,
and arrow appear in red.
* The patient sample did not reach endpoint.
↑
The patient sample result is above the reference range. On the screen, the
result and arrow appear in red.
↓
The patient sample result is below the reference range. On the screen, the
result and arrow appear in red.
↑↑
The patient sample result is above the action range. On the screen, the result
and arrow appear in red.
↓↓
The patient sample result is below the action range. On the screen, the result
and arrow appear in red.
(Continued)