Brocade BigIron RX Series Configuration Guide - Manual (Page 999)

BigIron RX Series Configuration Guide 921
53-1002484-04
Displaying BGP4 information
27
TABLE 141 BGP4 network information
This field... Displays...
Number of BGP Routes matching
display condition The number of routes that matched the display parameters you entered.
This is the number of routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status.
The status code appears in the left column of the display, to the left of
each route. The status codes are described in the command’s output.
NOTE: This field appears only if you do not enter the route option.
Prefix The network address and prefix.
Next Hop The next-hop router for reaching the network from the device.
Metric The value of the route’s MED attribute. If the route does not have a
metric, this field is blank.
LocPrf The degree of preference for this route relative to other routes in the
local AS. When the BGP4 algorithm compares routes on the basis of
local preferences, the route with the higher local preference is chosen.
The preference can have a value from 0 – 4294967295.
Weight The value that this router associates with routes from a specific
neighbor. For example, if the router receives routes to the same
destination from two BGP4 neighbors, the router prefers the route from
the neighbor with the larger weight.
Path The route’s AS path.
NOTE: This field appears only if you do not enter the route option.