Brocade BigIron RX Series Configuration Guide - Manual (Page 1161)

BigIron RX Series Configuration Guide 1083
53-1002484-04
Chapter
36
Inspecting and Tracking DHCP Packets
In this chapter
• Tracking of DHCP assignments. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1083
• Dynamic ARP inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1083
• DHCP snooping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1088
• DHCP relay agent information (DHCP option 82) . . . . . . . . . . . . . . . . . . 1090
• IP source guard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1093
Tracking of DHCP assignments
For enhanced network security, you can configure the Brocade device to inspect and keep track of
Dynamic Host Configuration Protocol (DHCP) assignments. To do so, use the following features.
Dynamic ARP inspection
NOTE
This feature is only supported on Layer 3 code.
Dynamic ARP Inspection (DAI) enables the Brocade device to intercept and examine all ARP request
and response packets in a subnet and discard those packets with invalid IP to MAC address
bindings. DAI can prevent common man-in-the-middle (MiM) attacks such as ARP cache poisoning,
and disallow mis-configuration of client IP addresses.
TABLE 178 Chapter contents
Description See page
Dynamic ARP Inspection – Intercepts and examines all ARP request and response
packets in a subnet, and blocks all packets that have invalid IP to MAC address bindings page 1083
DHCP Snooping – Filters replay DHCP packets from untrusted ports (those connected to
host ports), and allows DHCP packets from trusted ports (those connected to DHCP
servers) page 1088
IP Source Guard – Permits traffic with valid source IP addresses only, which is learned
from Dynamic ARP Inspection or DHCP snooping page 1093