Brocade BigIron RX Series Configuration Guide - Manual (Page 1021)

BigIron RX Series Configuration Guide 943
53-1002484-04
Displaying MBGP information
28
Syntax: show ip mbgp routes
Displaying the IP multicast route table
To display the IP multicast route table, enter the following command.
Syntax: show ip mroute [<ip-addr> <ip-mask> | bgp | static]
The <ip-addr> <ip-mask> options display IP multicast route information for a specific destination
address only.
The bgp parameter displays IP multicast route information for BGP routes only.
The static parameter displays IP multicast route information for static routes only.
BigIron RX#show ip mbgp route
Total number of BGP Routes: 2
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED s:STALE
Prefix Next Hop Metric LocPrf Weight Status
1 8.8.8.0/24 166.1.1.2 0 100 0 BI
AS_PATH:
2 31.1.1.0/24 166.1.1.2 0 100 0 BI
AS_PATH:
BigIron RX#show ip mroute
Type Codes - B:BGP D:Connected S:Static; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 9.9.9.0/30 DIRECT loopback 1 0/0 D
2 20.1.1.0/24 DIRECT ve 220 0/0 D
3 101.1.1.0/24 DIRECT ve 1 0/0 D
4 101.1.2.0/24 DIRECT ve 2 0/0 D
5 101.1.3.0/24 DIRECT ve 3 0/0 D
6 101.1.4.0/24 DIRECT ve 4 0/0 D
7 101.1.5.0/24 DIRECT ve 5 0/0 D
8 101.1.6.0/24 DIRECT ve 6 0/0 D
9 101.1.7.0/24 DIRECT ve 7 0/0 D
10 101.1.8.0/24 DIRECT ve 8 0/0 D
11 8.8.8.0/24 166.1.1.2 eth 4/1 200/0 B
12 31.1.1.0/24 166.1.1.2 eth 4/1 200/0 B