Displaying multicast neighbor information, Displaying the ipv6 pim multicast cache – Brocade BigIron RX Series Configuration Guide User Manual
Page 1434
1356
BigIron RX Series Configuration Guide
53-1002484-04
IPv6 PIM sparse
50
Displaying multicast neighbor information
To display information about the device’s IPv6 PIM neighbors, enter the following command at any
CLI level.
Syntax: show ipv6 pim nbr
This display shows the following information.
Displaying the IPv6 PIM multicast cache
To display the IPv6 PIM multicast cache, enter the following command at any CLI level.
RP
<
num
>
Indicates the RP number. If there are multiple RPs in the IPv6 PIM Sparse
domain, a line of information for each of them is listed, and they are numbered in
ascending numerical order.
priority
The RP priority of the candidate RP. During the election process, the candidate
RP with the highest priority is elected as the RP.
age
The age (in seconds) of this RP-set.
NOTE: If this device is not a BSR, this field contains zero. Only the BSR ages the
RP-set.
This field...
Displays...
Port
The interface through which the device is connected to the neighbor.
Neighbor
The IPv6 interface of the IPv6 PIM neighbor interface.
Phy_Port
Holdtime sec
Indicates how many seconds the neighbor wants this device to hold the entry for
this neighbor in memory. The neighbor sends the Hold Time in its Hello packets.
•
If the device receives a new Hello packet before the Hold Time received in
the previous packet expires, the device updates its table entry for the
neighbor.
•
If the device does not receive a new Hello packet from the neighbor before
the Hold time expires, the device assumes the neighbor is no longer
available and removes the entry for the neighbor.
Age sec
The number of seconds since the device received the last hello message from the
neighbor.
UpTime sec
The number of seconds the PIM neighbor has been up. This timer starts when
the device receives the first Hello messages from the neighbor.
This field...
Displays...
BigIron RX# show ipv6 pim nbr
Port Phy_Port Neighbor Holdtime Age UpTime
sec sec sec
e11/15 e11/15 fe80::45:27:49:4 105 20 1010
v312 e11/3 fe80::45:27:1:2 105 10 1900