Preforwarding state – Brocade BigIron RX Series Configuration Guide User Manual
Page 429

BigIron RX Series Configuration Guide
351
53-1002484-04
SuperSpan™
12
Each Brocade device that is configured for SuperSpan forwards the BPDU using the changed 
destination MAC address. At the other end of the tunnel, the Brocade device connected to the 
customer's network changes the destination MAC address back to the bridge group address 
(01-80-c2-00-00-00).
Preforwarding state
To ensure that the customer's network has time to converge at Layer 2 and prevent loops, the 
Brocade devices configured for SuperSpan use a special forwarding state, Preforwarding. The 
Preforwarding state occurs between the Learning and Forwarding states and by default lasts for 
five seconds. During the Preforwarding state, the Brocade device forwards tunneled BPDUs from 
customers only and does not forward data traffic. This ensures that the customer’s network will 
detect the Layer 2 loop and block a port. The SP network remains unblocked. After the 
Preforwarding state, the Brocade ports change to the Forwarding state and forward data traffic as 
well as BPDUs.
The default length of the Preforwarding state is five seconds. You can change the length of the 
Preforwarding state to a value from 3 – 30 seconds. 
shows an example of how the Preforwarding state is used.
FIGURE 35
SuperSpan preforwarding state
In this example, a customer has two links to the SP. Since the SP is running SuperSpan, the SP 
ports enter the Preforwarding state briefly to allow the customer ports connected to the SP to 
detect the Layer 2 loop and block one of the ports. 
NOTE
If you add a new device to a network that is already running SuperSpan, you must enable SuperSpan 
on the new device, at least on the VLANs that will be tunneling the customer traffic. Otherwise, the 
new device does not use the Preforwarding state. This can cause temporary loops in the network.
During Preforwarding state, SP
forwards all tunneled customer
BPDUs, allowing customer time
to detect the loop and block a port.
Cust 1
FWD
BLK
BPDU
Preforwarding
Tunneled BPDU
SP 1
SP 2
SuperSpan
root bridge
BPDU
Preforwarding
