Brocade BigIron RX Series Configuration Guide - Manual (Page 265)

BigIron RX Series Configuration Guide 187
53-1002484-04
Configuring an interface as the source for Syslog packets
7
BigIron RX(config)# interface ethernet 1/4
BigIron RX(config-if-e10000-1/4)# ip address 209.157.22.110/24
BigIron RX(config-if-e10000-1/4)# exit
BigIron RX(config)# ip telnet source-interface ethernet 1/4
TACACS and TACACS+ packets
To specify the lowest-numbered IP address configured on a virtual interface as the device’s source
for all TACACS and TACACS+ packets, enter commands such as the following.
BigIron RX(config)# interface ve 1
BigIron RX(config-vif-1)# ip address 10.0.0.3/24
BigIron RX(config-vif-1)# exit
BigIron RX(config)# ip tacacs source-interface ve 1
The commands configure virtual interface 1, assign IP address 10.0.0.3/24 to the interface, then
designate the interface as the source for all TACACS and TACACS+ packets from the device.
Syntax: ip tacacs source-interface ethernet <slot/port> | loopback <num> | ve <num>
The <num> parameter is a loopback interface or virtual interface number.
RADIUS packets
To specify the lowest-numbered IP address configured on a virtual interface as the device’s source
for all RADIUS packets, enter commands such as the following.
BigIron RX(config)# interface ve 1
BigIron RX(config-vif-1)# ip address 10.0.0.3/24
BigIron RX(config-vif-1)# exit
BigIron RX(config)# ip radius source-interface ve 1
The commands configure virtual interface 1, assign IP address 10.0.0.3/24 to the interface, then
designate the interface as the source for all RADIUS packets from the device.
Syntax: ip radius source-interface ethernet <slot/port> | loopback <num> | ve <num>
The <num> parameter is a loopback interface or virtual interface number.
Configuring an interface as the source for Syslog packets
You can configure the device to use the lowest-numbered IPv4 or IPv6 address configured on a
loopback interface, virtual interface, or Ethernet port as the source for all Syslog packets from the
device. The software uses the lowest-numbered IP or IPv6 address configured on the interface as
the source IP address for the packets.
For example, to specify the lowest-numbered IP address configured on a virtual interface as the
device's source for all Syslog packets, enter commands such as the following:.
BigIron RX(config)# interface ve 1
BigIron RX(config-vif-1)# ip address 10.0.0.4/24
BigIron RX(config-vif-1)# exit
BigIron RX(config)# ip syslog source-interface ve 1
The commands in this example configure virtual interface 1, assign IP address 10.0.0.4/24 to the
interface, then designate the interface's address as the source address for all Syslog packets.