Brocade BigIron RX Series Configuration Guide - Manual (Page 1533)

BigIron RX Series Configuration Guide 1455
53-1002484-04
Security/Management
E
Access
dot1x re-authenticate < portnum> “Re-authenticating a port manually” on page 1061
dot1x-enable “Enabling 802.1x port security” on page 1059
enable all I < portnum> [to < portnum> ] “Enabling 802.1x port security” on page 1059
global-filter-strict-security “Disabling and enabling strict security mode for
dynamic filter assignment”
on page 1056
maxreq < value> “Specifying the number of EAP-request/identity
frame retransmissions”
on page 1062
radius-server host < ip-addr> | < server-name> [auth-port
< number> acct-port < number> [authentication-only |
accounting-only | default [key 0 | 1 < string> [dot1x]]] ]
“Setting RADIUS parameters” on page 1053
re-authentication “Configuring periodic re-authentication” on
page 1060
servertimeout < seconds> “Specifying a timeout for retransmission of messages
to the authentication server”
on page 1062
show dot1x “Displaying 802.1x configuration information” on
page 1064
show dot1x config ethernet < slot/port> “Displaying 802.1x configuration information” on
page 1064
show dot1x ip-acl [all | ethernet < slot/port> | | begin
< expression> | exclude < expression> | include
< expression>]
“Displaying IP ACLs applied to an 802.1x-enabled
port”
on page 1070
show dot1x mac-address-filter [all | ethernet < slot/port>
[begin < expression> | exclude < expression> | include
< expression>]]
“Displaying MAC address filters applied to an
802.1x-enabled port”
on page 1069
show dot1x mac-session [brief [begin < expression> |
exclude < expression> | include < expression>]]
“Displaying information about the
dot1x-mac-sessions on each port”
on page 1070
“Displaying information about the ports in an 802.1x
multiple client configuration”
on page 1071
show dot1x statistics [all | ethernet < slot/port>] “Displaying 802.1x statistics” on page 1067
supptimeout < seconds> “Specifying a timeout for retransmission of
EAP-request frames to the client”
on page 1062
timeout quiet-period < seconds> “Setting the quiet period” on page 1061
timeout re-authperiod < seconds> “Configuring periodic re-authentication” on
page 1060
timeout tx-period < seconds> “Setting the interval for retransmission of
EAP-request/ identity frames”
on page 1061
Commands See ...
all-client < ip-addr> “Restricting all remote management access to a
specific IP address”
on page 60
Commands See ...