Enabling pbr, Configuration examples, Basic example – Brocade BigIron RX Series Configuration Guide User Manual
Page 727: Enabling pbr globally, Enabling pbr locally
BigIron RX Series Configuration Guide
649
53-1002484-04
Configuration examples
23
Enabling PBR
After you configure the ACLs and route map entries, you can enable PBR globally, on individual
interfaces, or both as described in this section. To enable PBR, you apply a route map you have
configured for PBR globally or locally.
Enabling PBR globally
To enable PBR globally, enter a command such as the following at the global CONFIG level.
BigIron RX(config)# ip policy route-map test-route
This command applies a route map named “test-route” to all interfaces on the device for PBR.
Syntax: ip policy route-map <map-name>
Enabling PBR locally
To enable PBR locally, enter commands such as the following.
BigIron RX(config)# interface ve 1
BigIron RX(config-vif-1)# ip policy route-map test-route
The commands in this example change the CLI to the Interface level for virtual interface 1, then
apply the “test-route” route map to the interface. You can apply a PBR route map to Ethernet ports
or virtual interfaces.
Syntax: ip policy route-map <map-name>
Enter the name of the route map you want to use for the route-map <map-name> parameter.
Configuration examples
This section presents configuration examples for:
•
•
•
“Setting the output interface to the null interface”
Basic example
The following commands configure and apply a PBR policy that routes HTTP traffic received on
virtual routing interface 1 from the 10.10.10.x/24 network to 5.5.5.x/24 through next-hop IP
address 1.1.1.1/24 or, if 1.1.1.x is unavailable, through 2.2.2.1/24.