Brocade BigIron RX Series Configuration Guide - Manual (Page 1526)

1448 BigIron RX Series Configuration Guide
53-1002484-04
OSPF version 4
E
default-information-originate [always] [metric < value>]
[metric-type < type>]
“Configure default route origination” on page 783
default-metric < value> “Modify default metric for redistribution” on
page 779
distance external | inter-area | intra-area < distance> “Modify administrative distance” on page 786
ip ospf area < ip-addr> “Assigning interfaces to an area” on page 765
ip ospf auth-change-wait-time < secs> “Change the timer for OSPF authentication changes”
on page 768
ip ospf database-filter all out “Block flooding of outbound LSAs on specific OSPF
interfaces”
on page 769
log all | adjacency | bad_packet [checksum] | database |
memory | retransmit “Specify types of OSPF Syslog messages to log” on
page 794
metric-type type1 | type2 “Modify redistribution metric type” on page 786
redistribution bgp | connected | rip | [isis level-1|
level-1-2| level-2] | static [route-map
< map-name>]
“Enable route redistribution” on page 779
“Define redistribution filters” on page 777
rfc1583-compatibility “Modify OSPF standard compliance setting” on
page 793
router ospf “Enable OSPF on the router” on page 761
show ip ospf area
[
< area-id>] | [ < num>]
“Displaying OSPF area information” on page 797
show ip ospf border-routers
[
< ip-addr>]
“Displaying OSPF ABR and ASBR information” on
page 805
show ip ospf config “Configure external route summarization” on
page 782
“Displaying general OSPF configuration information”
on page 795
show ip ospf database external-link-state [advertise
< num>] | [extensive] | [link-state-id < ip-addr>] |
[router-id < ip-addr>] | [sequence-number < num(Hex)>] |
[status < num>]
“Displaying OSPF external link state Information” on
page 803
show ip ospf database link-state [advertise < num>] |
[asbr] | [extensive] | [link-state-id < ip-addr>] | [network] |
[nssa] | [router] | [router-id < ip-addr>] |
[sequence-number < num(Hex)>] | [summary]
“Displaying OSPF database link state information” on
page 804
show ip ospf interface [ < ip-addr>] “Displaying OSPF interface information” on page 799
show ip ospf neighbor
[router-id
< ip-addr>] | [ < num>]
“Displaying OSPF neighbor information” on page 798
show ip ospf redistribute route
[
< ip-addr> < ip-mask>]
“Displaying the routes that have been redistributed
into OSPF”
on page 802
show ip ospf routes [ < ip-addr>] “Displaying OSPF route information” on page 801
show ip ospf trap “Displaying OSPF trap status” on page 806
show ip ospf virtual link [ < num>] “Displaying OSPF virtual link information” on
page 808
Commands See ...