Brocade BigIron RX Series Configuration Guide - Manual (Page 1067)

BigIron RX Series Configuration Guide 989
53-1002484-04
Configuring BFD for the specified protocol
30
Clearing BFD neighbor sessions
You can clear all BFD neighbor sessions or a specified BFD neighbor session using the following
command.
BigIron RX# clear bfd neighbor
Syntax: clear bfd neighbor [<IP-Address> | <IPv6-address>]
The <IP-Address> variable specifies the IPv4 address of a particular neighbor whose session you
want to clear BFD.
The <IPv6-Address> variable specifies the IPv6 address of a particular neighbor whose session you
want to clear BFD.
Executing this command without specifying an IP or IPv6 address clears the sessions of all BFD
neighbors.
Configuring BFD for the specified protocol
BFD can be configured for use with the following protocols:
• OSPFv2
• OSPFv3
• IS-IS
Configuring BFD for OSPFv2
You can configure your BigIron RX router for BFD on the OSPFv2 protocol for all OSPFv2 enabled
interfaces or for specific interfaces as shown in the following sections.
Enabling BFD for OSPFv2 for all interfaces
You can configure BFD for OSPFv2 on all of a router’s OSPFv2 enabled interfaces using the
command shown in the following”
BigIron RX (config)# router ospf
BigIron RX(config-ospf-router)# bfd all-interfaces
Syntax: [no] bfd all-interfaces
Stats: SysUpTime The amount of time that the system has been up.
Session Uptime The amount of time the session has been in the UP state.
LastSessionDownTimestamp The system time at which the session last transitioned from the UP state
to some other state.
Physical Port The physical port on which the peer is known.
Vlan Id The VLAN ID of the VLAN that the physical port is resident on.
TABLE 158 Display of BFD neighbor detail information (Continued)
This field... Displays...