Brocade BigIron RX Series Configuration Guide - Manual (Page 1293)

BigIron RX Series Configuration Guide 1215
53-1002484-04
Clearing RIPng routes from IPv6 route table
45
BigIron RX(config)# ipv6 router rip
BigIron RX(config-ripng-router)# poison-local-routes
Syntax: [no] poison-local-routes
To disable the sending of a triggered update, use the no version of this command.
Clearing RIPng routes from IPv6 route table
To clear all RIPng routes from the RIPng route table and the IPv6 main route table and reset the
routes, enter the following command at the Privileged EXEC level or any of the Config levels of the
CLI.
BigIron RX# clear ipv6 rip route
Syntax: clear ipv6 rip route
Displaying RIPng information
You can display the following RIPng information:
• RIPng configuration
• RIPng routing table
Displaying RIPng configuration
To display RIPng configuration information, enter the following command at any CLI level.
Syntax: show ipv6 rip
This display shows the following information:
TABLE 199 RIPng configuration fields
This field... Displays...
IPv6 RIP status/port The status of RIPng on the Brocade device. Possible status is “enabled” or
“disabled.”
The UDP port number over which RIPng is enabled.
Administrative distance The setting of the administrative distance for RIPng.
Updates/expiration The settings of the RIPng update and timeout timers.
BigIron RX# show ipv6 rip
IPv6 rip enabled, port 521
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 0, trigger updates 0
Distribute List, Inbound : Not set
Distribute List, Outbound : Not set
Redistribute: CONNECTED