Brocade BigIron RX Series Configuration Guide - Manual (Page 1441)

BigIron RX Series Configuration Guide 1363
53-1002484-04
Multicast Listener Discovery and source specific multicast protocols (MLDv2)
50
Setting the interface MLD version
You can use this command to set the MLD version (1 or 2) for the interface. You can select the
version of MLD by entering a command such as the following at the interface level.
BigIron RX(config-lbif-1)#ipv6 mld version
Syntax: ipv6 mld version <version-number>
Enter 1or 2 for <version-number>. Default is version 2
Displaying MLD information
The sections below present the show commands for MLD.
Displaying MLD group information
To display the list of multicast groups, enter a command such as the following.
Syntax: show ipv6 mld group
This field... Displays...
Interface < port-number > has x
groups
This message shows the ID of the interface and how many multicast groups it
has.
# Index for the MLD group.
ipv6 address IPv6 address of the multicast group.
phy-port The physical port to which the group belongs.
static Indicates if the group is a static group or not.
querier Indicates if the multicast group is a querier or not
life The number of seconds the interface can remain in its current mode.
mode Indicates if the filter mode of the multicast group is in INCLUDE or EXCLUDE
BigIron RX #show ipv6 mld group
Interface e6/18 has 11 groups
group phy-port static querier life mode
1 ff33::6:b:1 e6/18 no yes 0 incl
2 ff33::6:a:1 e6/18 no yes 0 incl
3 ff33::6:9:1 e6/18 no yes 0 incl
4 ff33::6:8:1 e6/18 no yes 0 incl
5 ff33::6:7:1 e6/18 no yes 0 incl
6 ff33::6:6:1 e6/18 no yes 0 incl
7 ff33::6:5:1 e6/18 no yes 0 incl
8 ff33::6:4:1 e6/18 no yes 0 incl
9 ff33::6:3:1 e6/18 no yes 0 incl
10 ff33::6:2:1 e6/18 no yes 0 incl
11 ff33::6:1:1 e6/18 no yes 0 incl