Brocade BigIron RX Series Configuration Guide - Manual (Page 555)

BigIron RX Series Configuration Guide 477
53-1002484-04
Configuration examples
17
. received packets dropped by owner = 0
. received packets with ip ttl errors = 0
. received packets with ip address mismatch = 0
. received packets with advertisement interval mismatch = 0
. received packets with invalid length = 0
- total number of vrrp-extended packets sent = 2004
. sent backup advertisements = 0
. sent packets with zero priority = 0
- received arp packets dropped = 0
- received proxy arp packets dropped = 0
- received ip packets dropped = 0
Syntax: show ip vrrp [brief | ethernet <slot>/<portnum> | ve <num> | stat]
Syntax: show ip vrrp-extended [brief | ethernet <slot>/<portnum> | ve <num> | stat]
The brief parameter displays the summary information. If you do not use this parameter, detailed
information is displayed instead.
The ethernet <slot>/<portnum> parameter specifies an Ethernet port. If you use this parameter,
the command displays VRRP information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays VRRP information only for the specified virtual interface.
The statistics parameter displays statistics.
The "received vrrp packets with checksum errors" shows the number of packets that is contained in
checksum errors.
The "received vrrp packets with invalid version number" shows the number of packets with invalid
versions.
The "received vrrp packets with unknown or inactive vrid" shows the number of packets that
contain virtual routers that are not configured on the device or its interface
Clearing VRRP or VRRPE statistics
To clear VRRP or VRRPE statistics, enter the following command at the Privileged EXEC level or any
configuration level of the CLI.
BigIron RX# clear ip vrrp-stat
Syntax: clear ip vrrp-stat
Configuration examples
The following sections contain the CLI commands options for implementing the VRRP and VRRPE
configurations shown in
Figure 85 on page 457 and Figure 86 on page 461.
VRRP example
To implement the VRRP configuration shown in Figure 85 on page 457, enter the following
commands.