Brocade BigIron RX Series Configuration Guide - Manual (Page 869)

BigIron RX Series Configuration Guide 791
53-1002484-04
Configuring OSPF
26
Originate LSA Trap: Disabled
Originate MaxAge LSA Trap: Disabled
Link State Database Overflow Trap: Disabled
Link State Database Approaching Overflow Trap: Disabled
OSPF Area currently defined:
Area-ID Area-Type Cost Prefix List In Prefix List Out
0 normal 0
1 normal 0 Area_1_Pfx_list in Area_1_Pfx_List_Out
Syntax: show ip ospf config
DIsplaying the configured IP prefix list
To only display the configured ip prefix-list, enter a command such as the following.
BigIron RX# show ip prefix-lists
ip prefix-list abc: 2 entries
seq 5 deny 2.3.4.0/24
seq 10 permit 4.5.0.0/16.
Syntax: show ip prefix-lists <prefix-list-name>
The <prefix-list-name> parameter specifies the name of the prefix list. You use this name when
applying the prefix list to an area.
Modifying OSPF traps generated
OSPF traps as defined by RFC 1850 are supported on BigIron RX.
You can enable or disable OSPF trap generation by doing the following.
1. Enabling SNMP traps for OSPF. (Refer to “Disabling and enabling SNMP traps for OSPF” on
page 792.)
2. Enable OSPF logging. (Refer to “Enabling OSPF logging” on page 793.)
Refer to Table 123 on page 791 for the list of the default settings for OSPF traps.
TABLE 123 Default settings for OSPF traps
Trap name default
Interface State Change Trap Enabled
Virtual Interface State Change Trap Enabled
Neighbor State Change Trap Enabled
Virtual Neighbor State Change Trap Enabled
Interface Configuration Error Trap Enabled
Virtual Interface Configuration Error Trap Enabled
Interface Authentication Failure Trap Enabled
Virtual Interface Authentication Failure Trap Enabled
Interface Receive Bad Packet Trap Enabled
Virtual Interface Receive Bad Packet Trap Enabled
Interface Retransmit Packet Trap Disabled
Virtual Interface Retransmit Packet Trap Disabled