Brocade BigIron RX Series Configuration Guide - Manual (Page 106)

28 BigIron RX Series Configuration Guide
53-1002484-04
Flash memory and PCMCIA flash card file management commands
2
This output displays that one switchover occurred.
Flash memory and PCMCIA flash card file management
commands
The BigIron RX Series system supports file systems in the following locations:
• The management module’s flash memory.
• A PCMCIA flash card inserted in the management module’s slots 1 or 2.
Table 32 outlines the root directory for each file system.
This section describes commands that manage the files in flash memory and on the flash cards.
You can use the file management commands to perform the following tasks:
• Format a flash card.
• Determine the current management focus.
• Switch the management focus.
• Display a directory of the files.
• Display the contents of a file.
• Display the hexadecimal output of a file.
BigIron RX# show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 24 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Sep 28 11:31:25:A:Power Supply 1, 1st left, not installed
Sep 28 11:31:25:A:Power Supply 3, middle left, not installed
Sep 28 11:31:25:A:Power Supply 4, middle right, failed
Sep 28 11:31:25:A:Power Supply 5, 2nd right, not installed
Dynamic Log Buffer (50 lines):
Sep 27 18:06:58:I:Interface ethernet6/2, state up
Sep 27 18:06:57:I:Interface ethernet3/2, state up
Sep 27 15:39:42:I:Interface ethernet3/2, state up
Sep 27 15:39:42:I:Interface ethernet6/2, state up
...
Sep 27 14:23:45:N:Module up in slot 6
Sep 27 14:23:45:N:Module up in slot 3
Sep 27 14:23:27:A:Management module at slot 9 state changed from standby
to active
TABLE 32 BigIron RX file system root directories
File system Root directory
Flash memory /flash/
PCMCIA flash card in slot 1 /slot1/
PCMCIA flash card in slot 2 /slot2/