Displaying bfd application information, Displaying bfd neighbor information – Brocade BigIron RX Series Configuration Guide User Manual
Page 1064
986
BigIron RX Series Configuration Guide
53-1002484-04
Displaying Bidirectional Forwarding Detection information
30
Displaying BFD application information
The following example illustrates the output from the show bfd application command.
BigIron RX# show bfd application
Registered Protocols Count: 3
Protocol Parameter
ospf 1
ospf6 0
isis_task 0
This display shows the following information.
Displaying BFD neighbor information
The following example illustrates the output from the show bfd neighbor command.
BigIron RX# show bfd neighbor
Total number of Neighbor entries: 2
NeighborAddress State Interface Holddown Interval RH
12.14.1.1 UP eth 3/1 300000 100000 1
12.2.1.1 UP eth 2/1 300000 100000 1
Syntax: show bfd neighbor [interface ethernet <slot/port> | interface pos <slot/port> | interface
ve <port-no>]
The interface ethernet option displays BFD neighbor information for the specified ethernet
interface only.
Maximum Exceeded Count for LPs The number of times the request to set up a BFD session was declined
because it would have resulted in exceeding the maximum number of
BFD sessions allowed on an Interface module.
LP
The number of the Interface module that the Current Session Count is
displayed for.
Sessions
The number of BFD sessions currently operating on the specified
Interface module.
BFD Enabled ports count
The number of ports on the router that have been enabled for BFD.
Port
The port that BFD is enabled on.
MinTx
The interval in milliseconds between which the router desires to send a
BFD message from this port to its peer.
MinRx
The interval in milliseconds that this router desires to receive a BFD
message from its peer on this port.
Mult
The number of times that the router will wait for the MinRx time on this
port before it determines that its peer router is non-operational.
Sessions
The number of BFD sessions originating on this port.
TABLE 156
Display of BFD application information
This field...
Displays...
Parameter
The parameter value passed by the protocol during registration with BFD.
TABLE 155
Display of BFD information (Continued)
This field...
Displays...