Brocade BigIron RX Series Configuration Guide - Manual (Page 1370)

1292 BigIron RX Series Configuration Guide
53-1002484-04
Configuring an IPv6 ACL
48
For ICMP
Syntax: [no] ipv6 access-list <acl name>
Syntax: permit | deny icmp <ipv6-source-prefix/prefix-length> | any | host
<source-ipv6_address>
<ipv6-destination-prefix/prefix-length> | any | host <ipv6-destination-address>
[ipv6-operator [<value>]]
[ [<icmp-type>][<icmp-code>] ] | [<icmp-messge>]
[802.1p-priority-matching <number>]
[dscp-marking <number> 802.1p-priority-marking <number> internal-priority-marking
<number>]
[dscp-marking <dscp-value> dscp-cos-mapping]
[dscp-cos-mapping]
For TCP
Syntax: [no] ipv6 access-list <acl name>
Syntax: permit | deny <tcp>
<ipv6-source-prefix/prefix-length> | any | host <source-ipv6_address> [tcp-udp-operator
[source-port-number]]
<ipv6-destination-prefix/prefix-length> | any | host <ipv6-destination-address>
[tcp-udp-operator [destination-port- number]]
[ipv6-operator [<value>]]
[match-all <tcp flags>] | [match-any <tcp flags>] |established
[802.1p-priority-matching <number>]
[dscp-marking <number> 802.1p-priority-marking <number> internal-priority-marking
<number>]
[dscp-marking <dscp-value> dscp-cos-mapping]
[dscp-cos-mapping]
For UDP
Syntax: [no] ipv6 access-list <acl name>
Syntax: permit | deny <udp>
<ipv6-source-prefix/prefix-length> | any | host <source-ipv6_address> [tcp-udp-operator
[source port number]]
<ipv6-destination-prefix/prefix-length> | any | host <ipv6-destination-address>
[tcp-udp-operator [destination port number]]
[ipv6-operator [<value>]]
[802.1p-priority-matching <number>]
[dscp-marking <number> 802.1p-priority-marking <number> internal-priority-marking
<number>]
[dscp-marking <dscp-value> dscp-cos-mapping]
[dscp-cos-mapping]