Brocade BigIron RX Series Configuration Guide - Manual (Page 1546)

1468 BigIron RX Series Configuration Guide
53-1002484-04
Topology
E
Topology
snmp-server enable traps
< trap-type>
“Disabling SNMP traps” on page 122
snmp-server enable traps holddown-time < secs> “Setting the SNMP Trap holddown time” on page 122
snmp-server host < ip-addr> [0 | 1] < string> [port
< value>]
“Specifying an SNMP trap receiver” on page 121
snmp-server location < string> “Entering system administration information” on
page 120
snmp-server trap-source loopback < num> | ethernet
< slot/port> | ve < num>
“Specifying a Single trap source” on page 121
sntp poll-interval < 1-65535> “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 127
sntp server < ip-addr> | < hostname> [ < version>] “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 127
static-mac-address < mac-addr> ethernet < portnum> [to
< portnum> ethernet < portnum>]
[priority < number>] [host-type | router-type | fixed-host]
“Assigning static MAC address entries to priority
queues” on page 485
system-max ip-static-route < num> “Displaying and modifying system parameter default
settings”
on page 133
system-max subnet-per-interface < num> “Displaying and modifying system parameter default
settings”
on page 133
system-max subnet-per-system < num> “Displaying and modifying system parameter default
settings”
on page 133
terminal length < number-of-lines> “Configuring terminal display” on page 132
unknown-unicast limit < number> “NP based multicast, broadcast, and
unknown-unicast rate limiting”
on page 519
Commands See ...
Commands See ...
master-vlan < vlan-id> “Configuring a topology group” on page 453
member-group < num> “Configuring a topology group” on page 453
member-vlan < vlan-id> “Configuring a topology group” on page 453
show topology-group [ < group-id>] “Displaying topology group information” on page 454
topology-group < group-id> “Configuring a topology group” on page 453