Enhancements in release 02.7.03 – Brocade BigIron RX Series Configuration Guide User Manual
Page 50
l
BigIron RX Series Configuration Guide
53-1002484-04
Enhancements in release 02.7.03
TABLE 5
Summary of enhancements in release 02.7.03
Enhancement
Description
See page
System Monitoring
Service (SYSMON)
This feature was introduced in the 02.6.00c
patch release. It monitors the hardware in the
system to detect, report, and in some cases
isolate and recover hardware errors in the
system. When an error or event occurs,
SYSMON generates Syslog messages, which
must be reported to Brocade Technical Support
This enhancement was introduced in Patch
Release 02.7.02a and has been added to this
issue of the BigIron RX Series Configuration
Guide.
Book: BigIron RX Series
Configuration Guide
Chapter:
clear ipv6 ospf
command
The clear ipv6 ospf CLI command has been
deprecated
This enhancement was introduced in Patch
Release 02.7.02c and has been added to this
issue of the BigIron RX Series Configuration
Guide.
N/A
switchover command
When you enter the switchover command, the
CLI asks you to confirm your request. Enter Y to
continue or N to cancel your request.
This enhancement was introduced in Patch
Release 02.7.02c and has been added to this
issue of the BigIron RX Series Configuration
Guide.
Book: BigIron RX Series
Configuration Guide
Chapter:
Section:
the standby management module”
Support for active cable
for 16-port 10 Gigabit
Ethernet module
10 Gbps Direct Attached Small Form-Factor
Pluggable (SFP+) copper cable (1m, 3m, 5m) is
available for the 16-port 10 Gigabit Ethernet
module
Book: Brocade BigIron RX Series
Hardware Installation Guide
Monitoring I2C failure on
a management module
The show logging command can be use to
monitor I2C failures.
Book: Brocade BigIron RX Series
Hardware Installation Guide
Rebranded show version
command output
The output of the show version command now
shows "Brocade Communications"
Book: Brocade BigIron RX Series
Hardware Installation Guide
Rebranded RADIUS
Vendor specific attributes for RADIUS have
been renamed to "brocade-command-string",
"brocade-privilege-level", and
"brocade-command-exception-flag"
Book: BigIron RX Series
Configuration Guide
Chapter: “
Section: