Brocade BigIron RX Series Configuration Guide User Manual
Page 986
908
BigIron RX Series Configuration Guide
53-1002484-04
Displaying BGP4 information
27
RouterID
The neighbor’s router ID.
Description
The description you gave the neighbor when you configured it on the
device.
State
The state of the router’s session with the neighbor. The states are from
this router’s perspective of the session, not the neighbor’s perspective.
The state values are based on the BGP4 state machine values described
in RFC 1771 and can be one of the following for each router:
•
IDLE – The BGP4 process is waiting to be started. Usually, enabling
BGP4 or establishing a neighbor session starts the BGP4 process.
•
A minus sign (-) indicates that the session has gone down
and the software is clearing or removing routes.
•
ADMND – The neighbor has been administratively shut down. Refer
to
“Administratively shutting down a session with a BGP4 neighbor”
•
A minus sign (-) indicates that the session has gone down
and the software is clearing or removing routes.
•
CONNECT – BGP4 is waiting for the connection process for the TCP
neighbor session to be completed.
ACTIVE – BGP4 is waiting for a TCP connection from the neighbor.
If the state frequently changes between CONNECT and ACTIVE, there
may be a problem with the TCP connection.
•
OPEN SENT – BGP4 is waiting for an Open message from the
neighbor.
•
OPEN CONFIRM – BGP4 has received an OPEN message from the
neighbor and is now waiting for either a KEEPALIVE or
NOTIFICATION message. If the router receives a KEEPALIVE
message from the neighbor, the state changes to Established. If
the message is a NOTIFICATION, the state changes to Idle.
•
ESTABLISHED – BGP4 is ready to exchange UPDATE messages with
the neighbor.
NOTE: If there is more BGP data in the TCP receiver queue, a plus sign
(+) is also displayed.
If you display information for the neighbor using the show ip bgp
neighbor
<
ip-addr> command, the TCP receiver queue value will
be greater than 0.
Time
The amount of time this session has been in its current state.
KeepAliveTime
The keep alive time, which specifies how often this router sends keep
alive messages to the neighbor. Refer to
HoldTime
The hold time, which specifies how many seconds the router will wait for
a KEEPALIVE or UPDATE message from a BGP4 neighbor before deciding
that the neighbor is dead. Refer to
“Changing the keep alive time and
PeerGroup
The name of the peer group the neighbor is in, if applicable.
Multihop-EBGP
Whether this option is enabled for the neighbor.
RouteReflectorClient
Whether this option is enabled for the neighbor.
SendCommunity
Whether this option is enabled for the neighbor.
TABLE 138
BGP4 neighbor information (Continued)
This field...
Displays...