Brocade BigIron RX Series Configuration Guide - Manual (Page 829)

BigIron RX Series Configuration Guide 751
53-1002484-04
Displaying RIP filters
25
Syntax: show ip rip
This display shows the following information.
Clearing the RIP routes from the routing table
Clearing all the routes from the routing table
To clear RIP local routes, enter a command such as the following.
BigIron RX(config)#clear ip rip local routes
Syntax: clear ip rip local routes
To clear the RIP routes from the RIP database, enter a command such as the following.
BigIron RX(config)# clear ip rip routes
Syntax: clear ip rip routes <ip-addr> / <mask-bits>
Use the ip address to specify which routes in the database you want to clear.
Use the subnet mask to specify which subnets you want to clear.
NOTE
Using the clear ip route command will not clear routes learned through RIP.
TABLE 120 CLI display of neighbor filter information
This field... Displays...
RIP Summary area Shows the current configuration of RIP on the device.
Stat ic metric Shows the static metric configuration. ".not defined" means the route
map has not been distributed.
OSPF metric Shows what OSPF route map has been applied.
Neighbor filter table area
Index The filter number. You assign this number when you configure the filter.
Action The action the router takes for RIP route packets to or from the specified
neighbor:
•
deny – If the filter is applied to an interface’s outbound filter group,
the filter prevents the router from advertising RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface’s inbound filter group, the filter prevents the router from
receiving RIP updates from the specified neighbor.
•
permit – If the filter is applied to an interface’s outbound filter
group, the filter allows the router to advertise RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface’s inbound filter group, the filter allows the router to
receive RIP updates from the specified neighbor.
Neighbor IP Address The IP address of the RIP neighbor.