Brocade BigIron RX Series Configuration Guide - Manual (Page 1433)

BigIron RX Series Configuration Guide 1355
53-1002484-04
IPv6 PIM sparse
50
Displaying RP information for a PIM sparse group
To display RP information for a PIM Sparse group, enter the following command at any CLI level.
Syntax: show ipv6 pim rp-hash <group-addr>
The <group-addr> parameter is the address of an IPv6 PIM Sparse IP multicast group.
This display shows the following information.
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
Syntax: show ipv6 pim rp-set
This display shows the following information.
Group address Indicates the IPv6 PIM Sparse multicast group address using the listed RP.
RP address Indicates the Iv6 address of the Rendezvous Point (RP) for the listed PIM
Sparse group.
This field... Displays...
RP Indicates the IPv6 address of the Rendezvous Point (RP) for the specified
IPv6 PIM Sparse group.
Following the IPv6 address is the port or virtual interface through which this
device learned the identity of the RP.
Info source Indicates the IPv6 address on which the RP information was received.
Following the IPv6 address is the method through which this device learned
the identity of the RP.
This field... Displays...
Number of group prefixes The number of IPv6 PIM Sparse group prefixes for which the RP is responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
RPs expected/received Indicates how many RPs were expected and received in the latest Bootstrap
message.
This field... Displays...
BigIron RX#show ipv6 pim rp-hash ff1e::1:2
RP: 2001:3e8:255:255::17, v2
Info source: 2001:3e8:255:255::17, via bootstrap
BigIron RX#
BigIron RX#show ipv6 pim rp-set
Number of group prefixes Learnt from BSR: 1
Group prefix = ff00::/8 # RPs expected: 1
# RPs received: 1
RP 1: 2001:3e8:255:255::17 priority=0 age=0
BigIron RX#